Hello, I hope you guys don't mind me posting this, but I just got my 4th gen seats a few days ago, and decided to install them after work tonight. I can't say everything went well, but removal was going and it was all done within 30min (I ran into some problems.. one of the brackets was bent for example.) Anyway, so I install the bench back seat, the old seat belt holsters for them, and move on the bottom cushion. Can't get the screw to keep turning in, having difficulty. So I move on to behind driver seat, goes in like a dream. 20seconds I had that baby in and torqued down. Go back to the other side, apply more pressure and bam screw goes up. The bracket is now spinning, cannot remove screw...Has anyone else had this problem? What do you guys think I should do? It's pretty easy to dislodge the cushion by simply getting out of the car. Try not to yell at me, I tried to do good

Thanks,