putting a berlinetta dash in an IROC
Joined: Aug 1999
Posts: 5,259
Likes: 459
From: RI
Car: 1984 Camaro Berlinetta
Engine: LT1
Transmission: T56 6-speed
Axle/Gears: 4.11 LS1 Rear End
I did it -
It all worked too! My swap was actually the opposite however ,..... I replaced an 85 Berlinetta interior with one from an 86 Z. I sold that car over 2 years ago with 180k on it & it's still driving around today !
In my swap - the Z was an LG4 and so was the Berlinetta so the firewall wiring harness was pretty close to the same thing. There will probably be more work if your installing it into a fuel injected car.
Perhaps T.Burgess could supply you with those details, He's got a Tuned Port engine in his Berlinetta !
If you are serious about the swap - get a full parts car so you can take all the wiring harnesses from the Berlinetta as well as the heating system, dash housing, steering column, floor console, (ect... ect...)
John in RI
Webmaster@Berlinetta.Info
It all worked too! My swap was actually the opposite however ,..... I replaced an 85 Berlinetta interior with one from an 86 Z. I sold that car over 2 years ago with 180k on it & it's still driving around today !
In my swap - the Z was an LG4 and so was the Berlinetta so the firewall wiring harness was pretty close to the same thing. There will probably be more work if your installing it into a fuel injected car.
Perhaps T.Burgess could supply you with those details, He's got a Tuned Port engine in his Berlinetta !
If you are serious about the swap - get a full parts car so you can take all the wiring harnesses from the Berlinetta as well as the heating system, dash housing, steering column, floor console, (ect... ect...)
John in RI
Webmaster@Berlinetta.Info
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
Exterior Parts for Sale
5
Apr 4, 2016 12:50 PM
mustangman65_79
Body
3
Aug 11, 2015 03:17 PM
