89 Iroc - bumper cover stud strip to hang GFX
Thread Starter
Joined: Feb 2001
Posts: 8,494
Likes: 411
From: Sophia, NC
Car: 2016 Camaro SS + 1986 Z28
89 Iroc - bumper cover stud strip to hang GFX
Anyone know where to pick up the metal stud strip that sits right below the side turn signal? It's got 3 studs and the front air dam/GXF hangs on it.
Can't seem to find it. Lookin' for both sides. Got mine apart, but they're both so rusted out I'm surprised I didn't snap all the studs off.
Can't seem to find it. Lookin' for both sides. Got mine apart, but they're both so rusted out I'm surprised I didn't snap all the studs off.
Junior Member
Joined: Jul 2017
Posts: 33
Likes: 0
From: East Texas
Car: 89 RS LT1 Swap
Engine: LT1 5.7L
Transmission: 4L60E
Re: 89 Iroc - bumper cover stud strip to hang GFX
On Probation
Joined: Apr 2007
Posts: 1,592
Likes: 18
From: Syracuse NY
Car: 84 Z-28
Engine: 305 HO
Transmission: r-700
Axle/Gears: 3:73
Re: 89 Iroc - bumper cover stud strip to hang GFX
Hmmm.......
NO fronts used on fleabay.
Rears yes.
NEW repops are only $62 https://www.classicindustries.com/pr...k80061.htmlcks
Same brand diff. seller $72 bucks !
NO fronts used on fleabay.
Rears yes.
NEW repops are only $62 https://www.classicindustries.com/pr...k80061.htmlcks
Same brand diff. seller $72 bucks !
Thread Starter
Joined: Feb 2001
Posts: 8,494
Likes: 411
From: Sophia, NC
Car: 2016 Camaro SS + 1986 Z28
Re: 89 Iroc - bumper cover stud strip to hang GFX
I found a few.
https://www.ebay.com/itm/85-90-Z28-I...JYkgST&vxp=mtr
Gonna remove mine and see if I can't clean 'em up first... Hate to snap a stud off during re installation.
https://www.ebay.com/itm/85-90-Z28-I...JYkgST&vxp=mtr
Gonna remove mine and see if I can't clean 'em up first... Hate to snap a stud off during re installation.
Joined: Sep 2007
Posts: 1,546
Likes: 123
From: Fayette County, OH
Car: basic third gens
Engine: that I like
Transmission: to restore
Axle/Gears: and enjoy
Re: 89 Iroc - bumper cover stud strip to hang GFX
I've always just made new ones. A strip of flat stock, drill three holes, weld in three studs (just bolts with the heads cut off, lol).