I have made stainless steel brake lines for the whole car using -3 an 37 degree flares. I need an adapter to go from -3 an to 10mm x 1.0 bubble flare for the front brake lines. Or maybe there is another way? Please help.

 

this one?
http://www.classicindustries.com/con...Number=2206890

 

I need male not female 10mm x 1.0 bubble flare.

 

i have never seen a male bubble flare fitting, except where it was on a hardline. I Dont think it exists.

 

I bought this one from Jeg's.

#3 to 10mm x 1.0 Male Beveled
799-640431

When I recieved it the fittings in the box were inverted flare.

After several days of phone calls to Jeg's they said that they couldn't get the one pictured on their website for p/n 640431.

 

well i'll be damned, there it is. Maybe give Russell a call? maybe they can help out more than jegs.

 

I called Russell/Edelbrock and they were just as confused. Long story short I just installed stainless steel braided lines. All better now.