Master cylinder cap keeps popping off
07-08-2015, 08:21 PM
#1
Senior Member
Thread Starter
Join Date: May 2011
Location: New Bedford MA
Posts: 855
Likes: 0
Received 1 Like
on
1 Post
Car: 1988 Gta trans am project 1-1/2
Engine: 86 4 bolt main cammed sbc 355 hsr
Transmission: 89 wc bw t5
Axle/Gears: Bw 9 bolt (3.27) pbr 11in
Master cylinder cap keeps popping off
Ok so i finally finished my LS1 brake upgrade and installed new drilled and slotted pbr rotors and pads im also using a 1Le master a wilwood single in single out adjustable prop valve and the front are right to the calipers for full pressure i finally bled all the brakes nice high pedal but every time i actually step on the pedal hard the master cyl cap pops off do you think i have to back the adjustment off of the adjustment **** on the wilwood prop valve or is something hooked up wrong
07-09-2015, 02:54 AM
#2
Supreme Member
Join Date: Jul 2007
Location: Howard Lake, MN
Posts: 1,293
Likes: 0
Received 4 Likes
on
4 Posts
Car: 86 Camaro
Engine: 355- hopefully a 5.3 this summer
Transmission: 700r4
Axle/Gears: 3.42
Re: Master cylinder cap keeps popping off
make sure the cap is pushed on all the way, and make sure that you have a little bit of air space in the top of the reservoir, i think it's supposed to be about 1/2" below the top..
Thread
Thread Starter
Forum
Replies
Last Post
dbrochard
Engine/Drivetrain/Suspension Parts for Sale
6
09-19-2015 08:13 PM
Street Lethal
Miscellaneous Third Gen Items!
0
09-07-2015 01:09 PM
