1987 IROC, LT1 Installed, 11,800 miles
Thread Starter
Senior Member
Joined: Oct 1999
Posts: 566
Likes: 0
From: New Britain, CT, U.S.A
Car: '87 IROC
Engine: LT1 350
Transmission: 700-R4
1987 IROC, LT1 Installed, 11,800 miles
I'm selling my baby. I've had this car since I was 19 and it's been my project for the last 5 years. I finally completed it about 2 years ago, and now I don't have the time to have fun with it :-(. I've put almost triple my asking price into this car so it hurts a lot to have to let it go. Let's get to the goodies.
The car has 11,800 miles on it. No, I'm not kidding. The previous owner bought the car brand new, reinforced the frame, and took it to drag racing only. He eventually got the car down to 9.4 seconds in the 1/4 mile. The body is in *pristine* condition, and the interior was wrapped in plastic during most of this cars existence. Hell even the seats in the car were wrapped in bags and never really sat in until I bought the car and put it back on the street. The car still smells dealer fresh on the inside. I've taken care of the paint using a meticulous Zaino process, it absolutely shines, I've taken 1st prize at a few car shows. The engine bay detailing is superb, considering it's a 19 year old engine bay with heavy customization.
List of mods:
Engine
New LT1 Crate motor (4 bolt main)
CCXE230-236 camshaft
Ported LT1 heads
58mm Throttle body
Port matched intake
Accel DFI Gen 6 Engine management
A/C Delete
LT4 Resin Valve Covers
Crange Gold 1.6 Self Aligning rockers
CSI Electric Waterpump
Brand new GM Optispark
MSD 6AL Ignition controller
Taylor Wires - MSD ignition Coil
Dyno'd in at 371 RWHP
Exhaust:
Hooker Full Length headers
Custom 3" exhaust
Borla Mufflers (Similar to 4th gen corvette)
Hi-flow cat/Test pipe (Bolt in whichever you want)
Transmission:
Built 700-R4 tranny from BowtieOverdrives.com
Super Yank 3500 Tourque Converter
Manual Torque Converter Lock-up Switch
Transmission Cooler
Hurst Dual Gate Shifter
Rear-End:
Moser 9" rear axle with 3.90 gears and a Detroit Locker.
LS1 Driveshaft
Driveshaft Loop
Fuel System
Stock Fuel lines, modified to mate with LT1
Walbro Hi-flow Fuel pump
Adjustable Fuel Pressure regulator
Brakes
Stock 4wheel disc brakes
Brand new Stainless Steel hard lines and braided lines
Hurst Line Lock
Vacuum Reserve Canister
Suspension
Coil over rear suspension with ladder bars.
Sub-frame connectors
8 pt Chro-moly Roll cage with Window net
(Extremely solid car, not even stress cracks in the roofline)
Ed Quay modified front K-member (for deep oil pan)
Wheels
Stock IROC wheels
Nitto 555R drag radials mounted on rear tires
Stock Eagle VR50 Tires on the fronts (with tread)
Interior
Radio Delete plate
DFI cable installed in the Ash Tray
Hurst Dual Gate Shifter
Rear Firewall - Modified to accept a Fuel Cell
Battery located in a battery box in the trunk
Pull switch for battery (NHRA approved)
*Everything* is like new or near brand new condition
That about sums it up and I know I'm forgetting tons of stuff. Please e-mail me if interested and I can fill you in on all the details and answer any questions you may have. I'm in no hurry to sell. If you would like pictures, I have zipped up Hi-res photos for you to download. It's about 11 MB. http://home.comcast.net/~markolc/images/SAVE0008.zip My email address is markolc@comcast.net please feel free to ask me any questions.
$12,900 obo.





The car has 11,800 miles on it. No, I'm not kidding. The previous owner bought the car brand new, reinforced the frame, and took it to drag racing only. He eventually got the car down to 9.4 seconds in the 1/4 mile. The body is in *pristine* condition, and the interior was wrapped in plastic during most of this cars existence. Hell even the seats in the car were wrapped in bags and never really sat in until I bought the car and put it back on the street. The car still smells dealer fresh on the inside. I've taken care of the paint using a meticulous Zaino process, it absolutely shines, I've taken 1st prize at a few car shows. The engine bay detailing is superb, considering it's a 19 year old engine bay with heavy customization.
List of mods:
Engine
New LT1 Crate motor (4 bolt main)
CCXE230-236 camshaft
Ported LT1 heads
58mm Throttle body
Port matched intake
Accel DFI Gen 6 Engine management
A/C Delete
LT4 Resin Valve Covers
Crange Gold 1.6 Self Aligning rockers
CSI Electric Waterpump
Brand new GM Optispark
MSD 6AL Ignition controller
Taylor Wires - MSD ignition Coil
Dyno'd in at 371 RWHP
Exhaust:
Hooker Full Length headers
Custom 3" exhaust
Borla Mufflers (Similar to 4th gen corvette)
Hi-flow cat/Test pipe (Bolt in whichever you want)
Transmission:
Built 700-R4 tranny from BowtieOverdrives.com
Super Yank 3500 Tourque Converter
Manual Torque Converter Lock-up Switch
Transmission Cooler
Hurst Dual Gate Shifter
Rear-End:
Moser 9" rear axle with 3.90 gears and a Detroit Locker.
LS1 Driveshaft
Driveshaft Loop
Fuel System
Stock Fuel lines, modified to mate with LT1
Walbro Hi-flow Fuel pump
Adjustable Fuel Pressure regulator
Brakes
Stock 4wheel disc brakes
Brand new Stainless Steel hard lines and braided lines
Hurst Line Lock
Vacuum Reserve Canister
Suspension
Coil over rear suspension with ladder bars.
Sub-frame connectors
8 pt Chro-moly Roll cage with Window net
(Extremely solid car, not even stress cracks in the roofline)
Ed Quay modified front K-member (for deep oil pan)
Wheels
Stock IROC wheels
Nitto 555R drag radials mounted on rear tires
Stock Eagle VR50 Tires on the fronts (with tread)
Interior
Radio Delete plate
DFI cable installed in the Ash Tray
Hurst Dual Gate Shifter
Rear Firewall - Modified to accept a Fuel Cell
Battery located in a battery box in the trunk
Pull switch for battery (NHRA approved)
*Everything* is like new or near brand new condition
That about sums it up and I know I'm forgetting tons of stuff. Please e-mail me if interested and I can fill you in on all the details and answer any questions you may have. I'm in no hurry to sell. If you would like pictures, I have zipped up Hi-res photos for you to download. It's about 11 MB. http://home.comcast.net/~markolc/images/SAVE0008.zip My email address is markolc@comcast.net please feel free to ask me any questions.
$12,900 obo.
Last edited by Markolc; Jun 18, 2006 at 07:00 PM.
Thread Starter
Senior Member
Joined: Oct 1999
Posts: 566
Likes: 0
From: New Britain, CT, U.S.A
Car: '87 IROC
Engine: LT1 350
Transmission: 700-R4
Originally Posted by tomclf
Would you be interetsed in a mvery clean 2002 Mutang GT?
Thread Starter
Senior Member
Joined: Oct 1999
Posts: 566
Likes: 0
From: New Britain, CT, U.S.A
Car: '87 IROC
Engine: LT1 350
Transmission: 700-R4
Originally Posted by drptop70ss
saw the price of 13900 over at the 4th gen site, getting into LS1 money there. Good luck 

Member
Joined: Apr 2004
Posts: 161
Likes: 0
From: Kirksville MO
Car: 1987 trans am GTA - sold
Engine: L98
Transmission: 700r4
well - I am working on this deal - do you have messenger ablilities? I would like to have online chat for moment to ask some questions if possible.
Trending Topics
Supreme Member
iTrader: (21)
Joined: Dec 2005
Posts: 4,075
Likes: 1
Car: 04 Silverado
Engine: 4.8
Transmission: auto
Dude,
Beautiful car, don't get discouraged or give it away for free. Here is some inspiration for you and shoot for the sky
https://www.thirdgen.org/forums/hist...70115-wow.html
Beautiful car, don't get discouraged or give it away for free. Here is some inspiration for you and shoot for the sky
https://www.thirdgen.org/forums/hist...70115-wow.html
Thread
Thread Starter
Forum
Replies
Last Post
mustangman65_79
Body
3
Aug 11, 2015 03:17 PM
1992 Trans Am
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 8, 2015 08:16 PM





