WTB 2nd or 3rd gen camaro in tx
WTB 2nd or 3rd gen camaro in tx
2nd or 3rd gen camaro in texas, preferabley dfw area.
all i ask is that it runs and drives, tagged/inspected, clear title all that.
mileage doesnt matter too much, would like to be a 350, auto or stick.
shoot em at me. not looking to spend a whole lot, but we will see.
all i ask is that it runs and drives, tagged/inspected, clear title all that.
mileage doesnt matter too much, would like to be a 350, auto or stick.
shoot em at me. not looking to spend a whole lot, but we will see.
Junior Member
Joined: May 2006
Posts: 13
Likes: 0
From: Tulsa,OK
Car: 04 gtp comp group
Engine: 3.8 sc
Re: WTB 2nd or 3rd gen camaro in tx
i have for sale a 1987 IROC Z TPI Camaro
everything was professionally built and have recepts for everything purchased
this car has been gone through from top to bottom mechanically and just about
has had everything replaced. car runs like new, car has zero leaks and no
problems. car has clear title and no lean on it. also has up to date tags.
any questions please ask.
OVER 15K invested, have receipts for all.
asking $5500 o.b.o
MOTOR:
motor is still tuned port injection
305 bored, stroked and decked to a 340
3750 stroke crank
KB stroker pistons 9 to 1 compression
comp cams with hydrolic roller kit and comp mag roller tip rockers
mellings high volume oil pump
ARP bolts
lift rate on the cam duration @ .050 intake 212 exhaust 218
lobe lift intake .3250 exhaust .3300
everything replaced under the hood:
new o2 sensors, waterpump, new cap, rotor, wires, plugs including distributor
new motor mounts, all new sensors, hoses, egr, tps, various gaskets way too much
stuff to list.
TRANNY:
700 r4 transmission rated for well over 600 HP
completely rebuilt including new sensors, everything replaced with heavy duty
parts.
stg. 2 shift kit, 2500 stall, Kevlar sleeves, hd sprag, hd drive shell.
REAR END:
completely rebuilt
373 gears
new posi, all new bearings with seals and new u-joints
SUSPENSION:
hyperflex polyurothane kit
new coil springs front and rear
new swaybars link pins/bushings
new upper and lower ball joints
inner and outer tie rods
new center link
new shocks all around
new wheel bearings
EXHAUST:
BBK shorty headers wrapped in header wrap.
all new 3" exhaust with Y pipe
all in the stock location with new 40 series flowmaster
BRAKES:
new wheel cylinders, shoes, drums, hardware,
brake lines, calipers, rotors and pads
INTERIOR:
new heater core
replaced steering column
seats are out of a 96 firebird no tears
new carpet
grant wood grain wheel
have all interior pieces except for the headliner
have an extra grey interior
BODY:
extra set of t-tops (no leaks)
stock paint needs a new coat of clear
extra hood
TIRES:
in the front two 235/55 R 16"
in the rear two 295/50 R 16"
tires have under 3k on them, good tread
everything was professionally built and have recepts for everything purchased
this car has been gone through from top to bottom mechanically and just about
has had everything replaced. car runs like new, car has zero leaks and no
problems. car has clear title and no lean on it. also has up to date tags.
any questions please ask.
OVER 15K invested, have receipts for all.
asking $5500 o.b.o
MOTOR:
motor is still tuned port injection
305 bored, stroked and decked to a 340
3750 stroke crank
KB stroker pistons 9 to 1 compression
comp cams with hydrolic roller kit and comp mag roller tip rockers
mellings high volume oil pump
ARP bolts
lift rate on the cam duration @ .050 intake 212 exhaust 218
lobe lift intake .3250 exhaust .3300
everything replaced under the hood:
new o2 sensors, waterpump, new cap, rotor, wires, plugs including distributor
new motor mounts, all new sensors, hoses, egr, tps, various gaskets way too much
stuff to list.
TRANNY:
700 r4 transmission rated for well over 600 HP
completely rebuilt including new sensors, everything replaced with heavy duty
parts.
stg. 2 shift kit, 2500 stall, Kevlar sleeves, hd sprag, hd drive shell.
REAR END:
completely rebuilt
373 gears
new posi, all new bearings with seals and new u-joints
SUSPENSION:
hyperflex polyurothane kit
new coil springs front and rear
new swaybars link pins/bushings
new upper and lower ball joints
inner and outer tie rods
new center link
new shocks all around
new wheel bearings
EXHAUST:
BBK shorty headers wrapped in header wrap.
all new 3" exhaust with Y pipe
all in the stock location with new 40 series flowmaster
BRAKES:
new wheel cylinders, shoes, drums, hardware,
brake lines, calipers, rotors and pads
INTERIOR:
new heater core
replaced steering column
seats are out of a 96 firebird no tears
new carpet
grant wood grain wheel
have all interior pieces except for the headliner
have an extra grey interior
BODY:
extra set of t-tops (no leaks)
stock paint needs a new coat of clear
extra hood
TIRES:
in the front two 235/55 R 16"
in the rear two 295/50 R 16"
tires have under 3k on them, good tread
Senior Member
iTrader: (3)
Joined: Dec 2004
Posts: 638
Likes: 0
From: Mass, Boston
Car: 1988 GTA Black notchback
Engine: 1991 L98 355 TWIN Superchagred
Transmission: 700r4 shift kit 2500 stall
Axle/Gears: www.cardomain.com/id/gtafanatic
Re: WTB 2nd or 3rd gen camaro in tx
heres mine looking for 12k B/o
i will ship MA/ NH
PM or e mail gtafanatic@hotmail.com
350
auto shift kit
373 rear
i will ship MA/ NH
PM or e mail gtafanatic@hotmail.com
350
auto shift kit
373 rear
Thread
Thread Starter
Forum
Replies
Last Post
I'llrocya
Interior Parts for Sale
3
Feb 2, 2016 11:43 PM
Mister_Johnny99
Interior Parts Wanted
0
Aug 14, 2015 12:59 PM
Zachattack0925
Tech / General Engine
2
Aug 12, 2015 09:54 PM
Zachattack0925
Transmissions and Drivetrain
4
Aug 12, 2015 09:52 PM




