for those of you that have put in 6.5" component sets in your sail panels how did you mount them? what material did you use. and if someone could, could you make me a template(out of paper) of what yours looks like(trace it) and mark where you had to drill holes. i would be greatly thankful.

TIA

 

i used 1/2" mdf.......i measured the slot....cut it out....trimmed to fit good...then used self tapping screws and silicone to seal her good...then i proceeded with a 4" hole saw.,...then i used a jigsaw..

 

i believe 1/8"+ plexi, cant remember the thickness. pulling them out cause i dont use them at all.

 

you have some? and your getting rid of them? how much would you want for em? also are they for 6.5" components?