No power to CD player...
Thread Starter
Member
Joined: Apr 2008
Posts: 371
Likes: 2
From: Chicago, IL
Car: 1987 IROC Z28
Engine: 305 TPI
Transmission: TKO 600
Axle/Gears: 3.45 (G92 package)
No power to CD player...
Hi Everyone,
I installed a new shifter over the weekend, which required me to remove the center console. I unplugged the CD player from all the connectors to put it in a safe place. As I went to re-install, I plugged everything back in and turned the ignition on and it worked. I was listening to the radio no problem. But as I pushed the unit into it's housing and bolt back in, everything went dead. I can't figure out for the life of me what happened.
What is the best way to diagnose the problem here?
I installed a new shifter over the weekend, which required me to remove the center console. I unplugged the CD player from all the connectors to put it in a safe place. As I went to re-install, I plugged everything back in and turned the ignition on and it worked. I was listening to the radio no problem. But as I pushed the unit into it's housing and bolt back in, everything went dead. I can't figure out for the life of me what happened.
What is the best way to diagnose the problem here?
Joined: Aug 2013
Posts: 4,815
Likes: 906
From: MICHIGAN
Car: 1988 Trans Am
Engine: L03
Transmission: 700R4
Axle/Gears: 10 Bolt 2.73 Open
Re: No power to CD player...
Personally, I'd start simple...check the fuse. A wire may have gotten pinched as you seated the radio. It's pretty snug in there.
Thread Starter
Member
Joined: Apr 2008
Posts: 371
Likes: 2
From: Chicago, IL
Car: 1987 IROC Z28
Engine: 305 TPI
Transmission: TKO 600
Axle/Gears: 3.45 (G92 package)
