Kenwood Sub Fix
Thread Starter
Junior Member
Joined: Sep 2000
Posts: 38
Likes: 0
From: Canada
Kenwood Sub Fix
The dust cap on my buddies 12"Kenwood Sub has started to work away from the cone. 
Is there any special type of glue that is the best to use to glue it back on?
Thanks in advance'
Joe
[This message has been edited by goosejg73 (edited May 02, 2001).]
Is there any special type of glue that is the best to use to glue it back on?
Thanks in advance'
Joe
[This message has been edited by goosejg73 (edited May 02, 2001).]
TGO Supporter
iTrader: (2)
Joined: Jul 1999
Posts: 13,579
Likes: 9
From: Readsboro, VT
Car: 85 IROC-Z / 88 GTA
Engine: 403 LSx (Pending) / 355 Tuned Port
Transmission: T56 Magnum (Pending) / T5
Axle/Gears: 3.42 / ?
Any decent glue will work fine. A good flexible epoxy will probably work best.
------------------
The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
"I didn't know a bored out Ford could go so slow" -Shenandoah
------------------
The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
"I didn't know a bored out Ford could go so slow" -Shenandoah
Thread
Thread Starter
Forum
Replies
Last Post
