Panels for 5.25 or 6x9
Thread Starter
Junior Member
Joined: May 2001
Posts: 13
Likes: 0
From: Savannah, GA
Panels for 5.25 or 6x9
i Have a pair of low end alpine 6x9's in the rear that have NO low end whatsoever, i was thinking of replacing them with some kappa's and then moving the alpines to kick panels ill make to the front. Then there is the alpine 7861 powering it all (i know this drives decent bass on its own). Should i leave the alpines in the back and add some dynomat and put new 5.25 in the front or put in some kappa 6x9s and move the others to the front? Really not sure what would sound best
TGO Supporter
iTrader: (2)
Joined: Jul 1999
Posts: 13,579
Likes: 9
From: Readsboro, VT
Car: 85 IROC-Z / 88 GTA
Engine: 403 LSx (Pending) / 355 Tuned Port
Transmission: T56 Magnum (Pending) / T5
Axle/Gears: 3.42 / ?
I'm not sure what exactly you're trying to do, but putting 6x9s in your kick panels isn't going to happen.
------------------
The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
"I didn't know a bored out Ford could go so slow" -Shenandoah
------------------
The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
"I didn't know a bored out Ford could go so slow" -Shenandoah
Junior Member
Joined: Jul 2000
Posts: 41
Likes: 0
From: Eau Claire, WI, USA
Leave the 6X9's in the back & get a component set for the front.
Or, just leave the 6X9's in the back & get new 4x6's in the dash.
There's no point in buying new 6x9's and then putting old 6x9's in the front when there's already a place for 4X6's in the front.
Or, just leave the 6X9's in the back & get new 4x6's in the dash.
There's no point in buying new 6x9's and then putting old 6x9's in the front when there's already a place for 4X6's in the front.
Thread
Thread Starter
Forum
Replies
Last Post
formula00ra
Interior Parts Wanted
1
Sep 28, 2015 11:50 AM
