I am having a brain fart and cant remember wiring schemes to achive a 4 ohm mono load.
I wanted to know if it was possible to achieve this with a single sub and i believe that 2 2ohm dvc subs can be wired for a 4ohm mono load. Please let me know if it is possible to wire a singel sub 4 ohm mono.

Thanks

Ryan



------------------
www.350iroc-z.com

 

With DVC 2 ohm single sub a 4 ohm mono load can be achived. All that you have to do is wire the two coils in series. Take a + on one coil and run that to the - on the other coil. Then you have a + on one coil and a - on the other, run this to the amp.
Wiring it in parallel would introduce a 1 ohm mono load to the amp.

------------------
88 Olds toronado trofeo 3.8. Black with gray leather
It's a 305 with the last two cylinders cut off...
hehe
165 H.P.
215 lb/ft Torque

Pioneer DEH-46DH
Pioneer TS-A6969
Stock "Dimensional Sound" Seperates up front.

My Trofeo Site
realdeal44 on AIM!
Gettin a Thirdgen soon!!

 

Just to be sure i am not an *** here is a pic of what you described to me

<img src=http://www.350iroc-z.com/miscpics/1dvcseries.gif>

The sub in the pic is 2 ohm dvc and is wired for a 4 ohm mono load right?

------------------
www.350iroc-z.com

 

correct, series doubles the load, parrallel cuts it in half, you diagram is Series.

------------------
88 Olds toronado trofeo 3.8. Black with gray leather
It's a 305 with the last two cylinders cut off...
hehe
165 H.P.
215 lb/ft Torque

Pioneer DEH-46DH
Pioneer TS-A6969
Stock "Dimensional Sound" Seperates up front.

My Trofeo Site
realdeal44 on AIM!
Gettin a Thirdgen soon!!