I am in the process of installing the following amps: PPI PC-2400 and a SONY ES 1004GX. The PPI puts out 400W RMS? and the SONY puts out 800W peak. I also have a 1 Farad cap going in, but i don't know if that make a difference. I already have a 60 amp fuse in from my old system, will i need a bigger fuse?

Please excuse the lack of EE knowledge, i am a ME

------------------

• 89 Formula 305 WS6
  SFC's, LCA's, Air Foil
  Spohn Panhard Bar
  Flowmaster Cat Back, Tranny Cooler
  A/F Ratio Meter (not a mod but it sure spurs interest)
  Trans Temp Gauge
  Most "Free" Mods
  3:73, Zexel Torsion Posi
  Catco cat
  CAI W/ K&N
  
  15.559 @ 88 MPH
  (Not good enough)

 

Keep the 60 in there. If you blow it, go to a higher fuse size. Just don't go bigger than the sum of the two amp fuses.

------------------

The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
Custom Thirdgen Subwoofer Enclosures
"I didn't know a bored out Ford could go so slow" -Shenandoah

 

Wow, thats simple!! Now that i think about that makes so much sense.