Q-Jet Question
Thread Starter
Joined: Aug 1999
Posts: 19,282
Likes: 103
From: Lawrence, KS
Car: Met. Silver 85 IROC/Sold
Engine: 350 HO Deluxe (350ci/330hp)
Transmission: T-5 (Non-WC)
Axle/Gears: Limited Slip 3.23's
Q-Jet Question
Is the cruise control stud, as seen in pic #3 of the link below, threaded into the accelerator bracket or is it secured on the back side with a nut? Any idea what the hole size or thread size is?
https://www.thirdgen.org/forums/carb...tuck-help.html
JamesC
https://www.thirdgen.org/forums/carb...tuck-help.html
JamesC
Joined: Sep 2005
Posts: 27,993
Likes: 2,485
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Q-Jet Question
The stud on the end goes through the throttle lever and is fastened with a nut.
6mm if memory serves but I could be wrong. (well I AM "wrong", with a capital "R"; but besides that, mistaken on this particular point)
6mm if memory serves but I could be wrong. (well I AM "wrong", with a capital "R"; but besides that, mistaken on this particular point)
Thread
Thread Starter
Forum
Replies
Last Post