fan control switch
Thread Starter
Supreme Member
iTrader: (4)
Joined: Nov 2003
Posts: 1,194
Likes: 0
From: santa barbara,ca
Car: 1990 iroc z
Engine: LSX 376 F1A
Transmission: 4l60e
Axle/Gears: 12 bolt 3.42
fan control switch
I want to buy a hypertech fan switch control but i would like to know what is involved of installing one ofe these? also i am running a 160* thermostat so which one do i buy? thanks,bryan
Member
Joined: May 2003
Posts: 140
Likes: 0
From: Sierra Vista, AZ
Car: 85 Trans Am
Engine: 383 TPI (Yes, TPI. Not for long though)
Transmission: 700r4
Assuming this particular switch is an automatic one, all that's involved is replacing the current fan switch located between cylinders 6 and 8 under the exhaust manifold on the head. I've heard it's easier to remove the starter or manifold or whatever, but I did it without removing anything. Took about 15 minutes. If this doesn't answer your question you could do a search. There are a few topics on this floating around.
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
2
Dec 16, 2024 01:50 PM
The_Phoenix
Interior Parts for Sale
12
Feb 4, 2016 07:10 AM
TA8487
Engine/Drivetrain/Suspension Wanted
1
Aug 16, 2015 12:21 PM