Just wanted to say thank you to everyone that helped me out....
Thread Starter
Senior Member

Joined: Apr 2001
Posts: 818
Likes: 1
From: Hudson, FL USA
Car: 1988 Camaro(92 Z28 clone)
Engine: Forged 383, AFR 195 419/430@wheels
Transmission: Monster 700R4 Yank 3600 stall
Axle/Gears: 9in Detroit locker-3.90's,35 spline
Just wanted to say thank you to everyone that helped me out....
This past week I was on vacation and decided to get the motor ready and drop it in my camaro. I was under a time constraint to get it in due to the fact that I had to 'rent' an engine lift from Nations Rent to do the install. I only had it for a few days so I had to make sure that everything was going to work correctly before I took it back casue if I needed it again I would have been screwed. Anyway, I had some last minute issues that needed resolving quickly, so I posted them on here and let me tell you. The responses I got from you guys were exactly what I needed exactly when i needed them and I really do appreciate it. I know that there are alot of members on this board and that there are numerous posts on many different topics, but I don't know if anyone ever took the time to write a post to thank everyone that helped them out so that is what I am doing, so THANK YOU! I am glad that I belong to this site, Paul Moore
TGO Supporter
Joined: Oct 2003
Posts: 2,069
Likes: 0
From: ready room
Car: NCC-1701-D (docked in AZ)
Engine: impulse drive
Transmission: fusion reactors
Axle/Gears: Rescued from the Borg by my crew
Same here...this site has helped me out several times when I was in the middle of something that wasn't going quite right. The response time here is super fast. I don't think there is another forum anywhere that even comes close to what you get here on TGO. It's simply amazing!!!
Thread
Thread Starter
Forum
Replies
Last Post
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM




