I just bought someones project Camaro, he ran out of funds after loosing his job so I got a real good deal on the whole setup, anyway he had most every part except a cam so I would like a little help picking one that will work good with this combination of parts, the car is a 92 CamaroRS it already has a killer drivetrain in it, 12-bolt with 3.42, Eaton posi, 5-speed TKO trans. The engine is a .030 over ZZ4 with a Callies Dragonslayer crank,6' H beam rods, KB forged 18.5 cc reverse dome pistons and the heads are Edelbrock 170cc E-tecs, Holley 950-22S 700 cfm TBI and the intake is a Edelbrock Air-Gap RPM Vortec. I think this comes out to about 9.5 to 1 compression, any suggestions on a good roller cam either hyd. or solid that will work good with TBI and pull to 6000RPM, thanks for any help.