hey i have a 350 TBI 5.7L L05 1227747 ecu and engine and can read the aldl stream with winaldl hooked up to A and E but i lose the signal when i begin to move the car

then after i begin to accelerate the stream dies
i am pulling the power from pin h in the aldl housing but i can plug it into the cig lighter and get the same response

also the 10k resistor between a and b just curious if it could have any adverse effects by leaving the resistor in line as i drove

 

found the problem it was the hot lead not having a 10k resistor.

the alternator brought the voltage up to ~13.5 after that the cable wouldnt respond

hope this helps someone else out