WinALDL stops responding
Thread Starter
Junior Member
Joined: Nov 2005
Posts: 13
Likes: 0
From: NY
Car: 90 Chevy G20
Engine: 350 TBI 5.7L LO5 1227747
Transmission: 700R4 3.42
WinALDL stops responding
hey i have a 350 TBI 5.7L L05 1227747 ecu and engine and can read the aldl stream with winaldl hooked up to A and E but i lose the signal when i begin to move the car
then after i begin to accelerate the stream dies
i am pulling the power from pin h in the aldl housing but i can plug it into the cig lighter and get the same response
also the 10k resistor between a and b just curious if it could have any adverse effects by leaving the resistor in line as i drove
then after i begin to accelerate the stream dies
i am pulling the power from pin h in the aldl housing but i can plug it into the cig lighter and get the same response
also the 10k resistor between a and b just curious if it could have any adverse effects by leaving the resistor in line as i drove
Thread Starter
Junior Member
Joined: Nov 2005
Posts: 13
Likes: 0
From: NY
Car: 90 Chevy G20
Engine: 350 TBI 5.7L LO5 1227747
Transmission: 700R4 3.42
found the problem it was the hot lead not having a 10k resistor.
the alternator brought the voltage up to ~13.5 after that the cable wouldnt respond
hope this helps someone else out
the alternator brought the voltage up to ~13.5 after that the cable wouldnt respond
hope this helps someone else out
Thread
Thread Starter
Forum
Replies
Last Post
sjorgens
Suspension and Chassis
7
Oct 1, 2015 07:54 PM
