--splicing-------------------------------------------------------------------
C15 splice D15 (Inj 2,4,6,8 "B")(2of2) D16 (Inj 2,4,6,8 "B") (new D16, old D15)
D16 splice D14 (Inj 1,3,5,7 "A")(2of2) D15 (Inj 1,3,5,7 "B") (new D15, old D14)

got this off the site and just want to make sure i did this right

c15 gets spliced into d15 and then it gets repinned into d16 on the new ecm

d16 gets spliced into d14 and then gets pepinned into d15 in the new ecm

this is how i understood it to be


also with the repins. im understanding that i am actually swapping wires
Repinning
---------------------------------------------------------------------
A11 (MAT) C12 (MAT)
D2 (Fan Ctrl) C1 (Fan Ctrl)
D8 (EGR Diag) C15 (EGR Diag)
B4 (EST Ctrl) D4 (EST Ctrl)
D13 (TPS Gnd) D2 (TPS/CTS/MAT Gnd) ^*
C9 (Fan Reqst) D11 (A/C Pres. Fan Reqst) %*%
B11 (MAF) B12 (MAF)
D12 (MAT/MAF Analog Gnd) A11 (MAF Analog Gnd) ^*
D15 (Inj 2,4,6,8 "B") (1of2) D16 (Inj 2,4,6,8 "B") ^*
D14 (Inj 1,3,5,7 "A") (1of2) D15 (Inj 1,3,5,7 "B") ^*

example: d13 pull it out of the 870 ecm location and put it in the d2 165 ecm location .do i then put the d2 back into the d13 position(am i just swapping locations?) i think i am over thinking this just need some reasurance