few noob questions. i have a 89 gta im looking into getting a ebl flash.
but does it come with software? or do i have to get a additional soaftware?
and is it woth it. and better than chip burning?

 

The only additional software required is the free version of Tuner Pro. Can grab that directly from Mark's site (www.tunerpro.net).

I think it's worth it (but I'm biased), and it beats chip burning all to heck. ECM is back under the dash where it belongs. Takes but a few seconds to flash in a tune.

You can use either the EBL Flash with the Port Mod, or the EBL P4 Flash. One main difference is in the amount of ECM harness connector re-pinning required. The EBL Flash uses the two stock connectors with a small handful of terminals/wires moved.

The EBL P4 Flash requires a third connector along with nearly all of the terminals/wires moved.

Both require a MAP sensor to be added. Which may be a 1-bar (N/A), 2-bar (15 psi boost), or 3-bar (30 psi boost).

There is currently a short thread on the DIY_PROM board where the EBL is being discussed. Along with a long thread where tuning with it is being discussed.

RBob.

 

thx rob..