Fuel Injector Sizing Supercharged
Thread Starter
Junior Member
Joined: May 2023
Posts: 13
Likes: 0
From: Wilmington Delaware
Car: 1989 Corvette
Engine: 350 L98
Transmission: 700R4
Axle/Gears: 3.07
Fuel Injector Sizing Supercharged
In need of some technical advice. I'm in the midst of assembling the parts needed to install a Paxton SN2000 on my 89 Corvette. I have recently purchased a Flash II ECM from Dynamic EFI. Id like to not run an FMU with my setup and would like to tune for injector size. Will #36 injectors be adequate for my setup? I will most likely only be seeing 5 PSI out of this blower.
Supreme Member
Joined: Apr 2010
Posts: 1,198
Likes: 126
From: Armstrong B.C.
Car: 1991 camaro Z28
Engine: Forged 370" LS turbo s488
Transmission: Built 4L80e FTI converter
Axle/Gears: MWC 9" 35 spline 3.25 gears
Re: Fuel Injector Sizing Supercharged
In need of some technical advice. I'm in the midst of assembling the parts needed to install a Paxton SN2000 on my 89 Corvette. I have recently purchased a Flash II ECM from Dynamic EFI. Id like to not run an FMU with my setup and would like to tune for injector size. Will #36 injectors be adequate for my setup? I will most likely only be seeing 5 PSI out of this blower.
Flow Calculator (fuelinjectorclinic.com)
Thread
Thread Starter
Forum
Replies
Last Post