Finally burned !!!!!!!!
Thread Starter
Member
Joined: Jun 2001
Posts: 151
Likes: 0
From: va.beach.va/usa
Car: 87 IROC (low 12's)
Engine: 400 sbc .040 over
Transmission: 700r mod
Finally burned !!!!!!!!
Between yesterday and 1:30 p.m. today I and friend of mine have successfully programmed,burned, and tested my 1st chip for my car!!!!!And it runs!!!!! After being at it for about 4 months
I believe my initial trials and tribulations were from a bad bin
or using the atmel chip(29c256) and the remote possibility of
it being defective.BTW for reference is it the starting address for
for the 29c256 04000 or is it the starting buffer at o4000?(for the 165 ecm) 32b d.f.) I would like to use it mainly for lacking an eraser. I will move on to the 6e soon after I enjoy (sofar getting the injector constants to 32) how it runs and car it for a spin.(still
in garage it's lunch time).thanks for all the help and more questions to come!!!
I believe my initial trials and tribulations were from a bad bin
or using the atmel chip(29c256) and the remote possibility of
it being defective.BTW for reference is it the starting address for
for the 29c256 04000 or is it the starting buffer at o4000?(for the 165 ecm) 32b d.f.) I would like to use it mainly for lacking an eraser. I will move on to the 6e soon after I enjoy (sofar getting the injector constants to 32) how it runs and car it for a spin.(still
in garage it's lunch time).thanks for all the help and more questions to come!!!
Supreme Member
Joined: Sep 2001
Posts: 1,355
Likes: 1
From: MN
Car: 2009 Pontiac G8 GXP
Engine: LS3
Transmission: 6L80E
Axle/Gears: 3.27
I think this is you Ray...
Congrats...I know that you have been working on this for a while...Hope this is the start to a good trend...
Congrats...I know that you have been working on this for a while...Hope this is the start to a good trend...
Thread
Thread Starter
Forum
Replies
Last Post
