Is this Programmer Good?
Thread Starter
Member
Joined: Jul 2001
Posts: 342
Likes: 0
From: Guam
Is this Programmer Good?
http://www.futurlec.com/EPROMProg.shtml
I'm planning on starting to burn my on chips and would like to know the things I need.
Any suggestion and Ideas will be greatly appreciated
Thanks.
I'm planning on starting to burn my on chips and would like to know the things I need.
Any suggestion and Ideas will be greatly appreciated
Thanks.
TGO Supporter
iTrader: (2)
Joined: Jul 1999
Posts: 13,579
Likes: 9
From: Readsboro, VT
Car: 85 IROC-Z / 88 GTA
Engine: 403 LSx (Pending) / 355 Tuned Port
Transmission: T56 Magnum (Pending) / T5
Axle/Gears: 3.42 / ?
Damn... good price.
As for whether it's any good or not I have no idea... but that's sure a great price!
As for whether it's any good or not I have no idea... but that's sure a great price!
Supreme Member
Joined: Jun 2000
Posts: 1,612
Likes: 0
From: the garage
Car: 84 SVO
Engine: Volvo headed 2.3T
Transmission: WCT5
Axle/Gears: 8.8" 3.73
Originally posted by RS91
Thanks for the info.... Any body else have an idea how to get me started... Thanks...
Thanks for the info.... Any body else have an idea how to get me started... Thanks...
https://www.thirdgen.org/newdesign/tech/promintro.shtml
also look into WinALDL for scanning software and Craig Moates has all the hard parts to get you going
Supreme Member
Joined: May 2002
Posts: 4,099
Likes: 2
Couple things to mention about that programmer. It doesn't come with the powersupply and it is a center NEAGTIVE connector. Most of the other programmers out there are center positive. It will need a 9-12VDC 800ma center negative P/S.
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM