does anyone have any LT4 hotcam etc Bins?
Thread Starter
Senior Member
Joined: Oct 1999
Posts: 548
Likes: 0
From: Dallas, Texas
Car: 1991 Z28
Engine: 5.3 Gen III SBC
Transmission: 4L80E NTC 258mm Stall
Axle/Gears: Trick Chassis 9" 3.50 S-Strac
does anyone have any LT4 hotcam etc Bins?
I'm not begging or anything but if someone let me use their bin just to see if it runs better than my stock chip. I have the stuff to scan but Im its not working
. I just started up the car for the first time and it definately does run rich at idle. (Like I was told it would with this cam)
I just want somthing so my eyes dont water when I go to work on my car. andI dont feel really good about running so rich on a new motor. Thanks,
Chris
. I just started up the car for the first time and it definately does run rich at idle. (Like I was told it would with this cam) I just want somthing so my eyes dont water when I go to work on my car. andI dont feel really good about running so rich on a new motor. Thanks,
Chris
Last edited by Chris Etemadi; Oct 26, 2002 at 01:25 AM.
Supreme Member
Joined: May 2000
Posts: 2,963
Likes: 3
Car: 1982 Z28
Engine: LS1
Transmission: T56
http://members.fbody.com/kevinc/bins/
The AFRP one is speed density, the ARAP one is MAF. Don't blame me if you blow your engine, use at your own risk, offer not valid where prohibited by law, batteries not included, etc.
The AFRP one is speed density, the ARAP one is MAF. Don't blame me if you blow your engine, use at your own risk, offer not valid where prohibited by law, batteries not included, etc.
Thread
Thread Starter
Forum
Replies
Last Post
TX-SleeperC5
Engine/Drivetrain/Suspension Parts for Sale
1
Sep 24, 2015 03:13 PM
