Epromer4
Thread Starter
Senior Member
Joined: Jul 1999
Posts: 784
Likes: 0
From: Sacramento, CA
Car: 89 Iroc
Engine: 383
Transmission: 700R4
Axle/Gears: 3.45
Epromer4
I just picked up an Epromer4 from a buddy and was wondering what experience others have had with them. I see now that there is a newer Epromer5 version but...oh well.
What are the main differences between the two and what are the limitations of this device compared to a PP or others?
I also have the newest versions of GMECMedit and WinBin. Which one works better?
Also what are the 'M27256FI' chips used for? I plugged it in to a search and nothing came back.
What are the main differences between the two and what are the limitations of this device compared to a PP or others?
I also have the newest versions of GMECMedit and WinBin. Which one works better?
Also what are the 'M27256FI' chips used for? I plugged it in to a search and nothing came back.
Thread Starter
Senior Member
Joined: Jul 1999
Posts: 784
Likes: 0
From: Sacramento, CA
Car: 89 Iroc
Engine: 383
Transmission: 700R4
Axle/Gears: 3.45
I just downloaded the newest version of Epromer5 software and it seems to work OK. My main question was does it (Epromer4 burner) have any limitations compared to the other burners?
Obviously those chips aren't for my setup.
Obviously those chips aren't for my setup.
Last edited by DannyT; Jul 22, 2003 at 08:41 AM.
