Need 165 ECM with MAP programming
Thread Starter
Member
Joined: Aug 2004
Posts: 151
Likes: 0
From: FL
Need 165 ECM with MAP programming
I have an application were I need to use the 165 computer (due to connectors) but with the programming for a MAP. Can anyone refernece me to a place that may discuss this application? Anyone has done it here? The harness being used has been repined to have the proper sensors in the right place. I just need help on how to get the MAP programming inot the 165. Thanks in advance 
Supreme Member
Joined: Feb 2000
Posts: 1,416
Likes: 0
From: Johnstown, Ohio
Car: 84 Z28
Engine: 355 (fastburn heads, LT4 HOT cam)
Transmission: 700R4
Axle/Gears: 9-bolt, 3.27
1227808 $5D code. It runs in a 165, but you only get 160 baud ALDL. I don't have any personal experience on this, but at has been done.
The other option that I've never seen discussed would be using the 4 cyl TBI $2B, $53, $83, or $94 code, but I don't know if there's much info out there for nay of them.
HTH
JP
The other option that I've never seen discussed would be using the 4 cyl TBI $2B, $53, $83, or $94 code, but I don't know if there's much info out there for nay of them.
HTH
JP
Thread
Thread Starter
Forum
Replies
Last Post
