PCM Tuning Help
Thread Starter
Junior Member
Joined: Jun 2004
Posts: 2
Likes: 0
From: GTA Toronto Mississauga area
Engine: Chevy 350 4 bolt main
Transmission: T5
PCM Tuning Help
Hi I am new to prom tuning and I am looking for some advice to start with a starter bin on a fresh 350 +.060
what bin to use and what mods I have to do
PCM is 1227165 86 TPI MAF Gutted screens
I perfer to use 6E code with VATS disabled
It is a 350 approx 10:1 - 10.5:1
Cam:
234/244 dur@.50
.488intake lift
.510 exhaust valve lift
Heads
(GM291) Cast iron 1967 327 heads
screw in stud & Guide plates
3 angle valve job
165cc intake runner ported
65cc exhaust runner ported
1.94 int valve
1.50 exh valve
Stock ported simeased TPI intake and runners
Ls1 Zo6 28.8 advertised gray top injectors 28.8 @43.5psi
T5 WC Transmission
2.77 POSI rear
what bin to use and what mods I have to do
PCM is 1227165 86 TPI MAF Gutted screens
I perfer to use 6E code with VATS disabled
It is a 350 approx 10:1 - 10.5:1
Cam:
234/244 dur@.50
.488intake lift
.510 exhaust valve lift
Heads
(GM291) Cast iron 1967 327 heads
screw in stud & Guide plates
3 angle valve job
165cc intake runner ported
65cc exhaust runner ported
1.94 int valve
1.50 exh valve
Stock ported simeased TPI intake and runners
Ls1 Zo6 28.8 advertised gray top injectors 28.8 @43.5psi
T5 WC Transmission
2.77 POSI rear
Supreme Member
Joined: Sep 2003
Posts: 1,409
Likes: 1
From: Texas
ARAP for the bin and put your screens back.
Do a lot of searching on ARAP and APYP. And read all the 165 stickies.
Then read them again.
Then read selected 8D stickies.
Then ask questions on stuff your confused on.
Your cam is mismatched to the rest of your combo. But that is a whole other issue... for a different board.
Do a lot of searching on ARAP and APYP. And read all the 165 stickies.
Then read them again.
Then read selected 8D stickies.
Then ask questions on stuff your confused on.
Your cam is mismatched to the rest of your combo. But that is a whole other issue... for a different board.
