Software glitch?
Thread Starter
Member
Joined: Nov 1999
Posts: 317
Likes: 0
From: st louis,mo. u.s.a.
Software glitch?
I have a 85 tpi setup,stock prom.Once in a while code45 pops up on the highway.The light stays on until the key is turned off.The o2 reads 900-950 mv when the ses is on.When i turn the car back on the mv go back to normal and no ses.Other than that it runs fine.Could the tps voltage a little high make this happen?
Supreme Member
Joined: Jun 2000
Posts: 7,554
Likes: 1
From: In reality
Car: An Ol Buick
Engine: Vsick
Transmission: Janis Tranny Yank Converter
<font face="Verdana, Arial" size="2">Originally posted by formula5:
I have a 85 tpi setup,stock prom.Once in a while code45 pops up on the highway.The light stays on until the key is turned off.The o2 reads 900-950 mv when the ses is on.When i turn the car back on the mv go back to normal and no ses.Other than that it runs fine.Could the tps voltage a little high make this happen?</font>
I have a 85 tpi setup,stock prom.Once in a while code45 pops up on the highway.The light stays on until the key is turned off.The o2 reads 900-950 mv when the ses is on.When i turn the car back on the mv go back to normal and no ses.Other than that it runs fine.Could the tps voltage a little high make this happen?</font>
45 is rich, there are a bunch of parameters that must be set to throw that code, one being a timer. So after you power down the timer is reset. reading rich when in a fail soft mode is normal
Thread
Thread Starter
Forum
Replies
Last Post
Anniversary-SS-man
Tech / General Engine
1
Apr 22, 2001 04:18 PM