ok well heres what I got and whats off the ECM and the chip.
92 RS 3.1 5 speed.

Comp numbers serial number 01227730 866651 M210192756

Chip BWAX 6865

Can this tell me what program I have on the chip???

 

ok according to that DIY-EFI site its a '730 comp and has the $8D or the $88. Are these both basically the same programs or what?. I have downloaded AZTY.bin and 730_AZTY_ecu and the azty_hac.dsm. I am downloading WINBIN again. so the question is what else do I need to start modding the bin? Or do I even have the right one even?

 

8D or 88 are the Mask identifiers, there are at least a dozen for the 1227730.
If with hex editor you look at location 0008 that will tell you want Mask your working on, then you can find the right editor.

8D was only used in v8s originally.

Traxions article at the top of the page is where to start.

 

AZTY is for an automatic trans car. It is the latest revision from GM for SD V6 AT cars. You have to find a MT bin but everything else looks good. As a comparison, there is a $88 hac available somewhere, I just don't remember where. Use that to check against WinBin. Sometimes you get errors in the ecu file that can be checked by looking at the hac.

 

ok so I have to find the Mt progam then? what will be the name of it?... I dunno I'll go look around...