Newbey Pocket programmer question
Thread Starter
Moderator
Joined: Mar 2001
Posts: 14,293
Likes: 195
From: Doghouse ······································ Car: 1989 Formula 350 Vert Engine: 350 L98 Transmission: 700R4 Axle/Gears: B&W 3.27
Car: 87 Formula T-Top, 87 Formula HT
Engine: 5.1L TPI, 5.0L TPI
Transmission: 700R4, M5
Axle/Gears: Sag 3.73, B&W 3.45
Newbey Pocket programmer question
Ok, I have done this before, but for some unknown reason, it does not want to do it again.
I am trying to write to the AT29C256's and make them work with my 165 ECM. I understand the loading portion about writing to the chip twice. I have done that in the past. But now it does not want to write to the upper block, only to the lower block.
to reiderate: I can write from 0000 to 3FFF no problem, but when I try to set the "Start of Buffer," "Start of Device" & "End of Device," it does not seem to care what I do, it only wants to write to 0000 to 3FFF, not to 4000 thru 7FFF.
I am using V3.12 12 June 01 For Windoze
ANY Ideas guys, I know you
I am trying to write to the AT29C256's and make them work with my 165 ECM. I understand the loading portion about writing to the chip twice. I have done that in the past. But now it does not want to write to the upper block, only to the lower block.
to reiderate: I can write from 0000 to 3FFF no problem, but when I try to set the "Start of Buffer," "Start of Device" & "End of Device," it does not seem to care what I do, it only wants to write to 0000 to 3FFF, not to 4000 thru 7FFF.
I am using V3.12 12 June 01 For Windoze
ANY Ideas guys, I know you
Thread
Thread Starter
Forum
Replies
Last Post
1988iroc350tpi
Tech / General Engine
8
Aug 14, 2015 07:52 PM