ready to get wet
#1
ready to get wet
i've been thinking about doing my own chips for some time i was originally planning to buy the APU1 usb prob package from moats but upon reading a little more and thinking about my bank account....well ok my wife was whining about the cost,low and behold read a little more and started looking into the Ostrich fro RT emu and the BURN1 to burn with with a few adapters and some flashable ROM chips, the only differences that i can see between the APU1 vs. the Ostrich/BURN1 it that the APU1 can datalog/burn in one unit and the Ostrich cannot......... I currently have 5 gasser trucks that i will be doing so the ostrich won't be staying in any of them. Should i get a datalog system as well?cos if i do get a datalog system it's even more $$ then the APU1 this is the only part that is cornfuzing me BTW the APU1 says it's out of stock or on backorder....eeek
#5
Supreme Member
iTrader: (2)
Join Date: Jan 2002
Location: Moorestown, NJ
Posts: 9,962
Likes: 0
Received 3 Likes
on
3 Posts
Car: 88 Camaro SC
Engine: SFI'd 350
Transmission: TKO 500
Axle/Gears: 9-bolt w/ 3.23's
If you have a very good intuative feel for how everything works, you can get by without datalogging all the time, but if your just starting out, datalogging is a must. Youll be guessing otherwise.
Thread
Thread Starter
Forum
Replies
Last Post
Glowsock
Tech / General Engine
2
09-11-2015 11:09 PM