Here we go...
Here we go...
Alright, I finally got a pocket programmer and eprom eraser. I have a 1988 5.7 TPI in which nothing was left stock. I was going to try to run a stock prom, but I decided I need a new one. After seeing how much a new one is and how unaccurate the mail order ones are, I decided to ATTEMPT (key word here) to burn my own. I know I need to datalog before I can accurately burn a chip, so I figured what the hell, Ill make my own cord to datalog with TunerPro and my laptop. How do I do this? I have searched on here, but I cant find a defenitive answer. Im sure it's been said before, but I cant find it. Thanks.
Joined: Apr 2004
Posts: 3,180
Likes: 3
From: Browns Town
Car: 86 Monte SS (730,$8D,G3,AP,4K,S_V4)
Engine: 406 Hyd Roller 236/242
Transmission: 700R4 HomeBrew, 2.4K stall
Axle/Gears: 3:73 Posi, 7.5 Soon to break
Re: Here we go...
The tuning guide in the sticky at the top 
Lots of info.
Lots of info.
Thread
Thread Starter
Forum
Replies
Last Post