RN PROM Holder Source Needed
Thread Starter
Member
Joined: Apr 2005
Posts: 195
Likes: 0
From: TACOMA WA
Car: 1992 rs 355 TBI **swapped**
Engine: 80 Ford Fiesta GHIA dual carb
Transmission: 72 Cutlass S 350/350 3.42
Axle/Gears: s10 tq converter/stock rear gear
RN PROM Holder Source Needed
Ok so what ive gathered is that the RN company sold to 3M, who cut out the lower volume RN lines, leaving no source for the plastic holders.
I need like more than i can get from a junkyard, so am i screwed or what?
Ive HEARD that you can buy like 100 at a time from some sources, yet no one has been able to point me their way.
I cant find it on google for sht.
plz help anyone!
I need like more than i can get from a junkyard, so am i screwed or what?
Ive HEARD that you can buy like 100 at a time from some sources, yet no one has been able to point me their way.
I cant find it on google for sht.
plz help anyone!
Thread Starter
Member
Joined: Apr 2005
Posts: 195
Likes: 0
From: TACOMA WA
Car: 1992 rs 355 TBI **swapped**
Engine: 80 Ford Fiesta GHIA dual carb
Transmission: 72 Cutlass S 350/350 3.42
Axle/Gears: s10 tq converter/stock rear gear
Re: RN PROM Holder Source Needed
update: Ok so Robinson Nugent is the manufacture, pn PRC-246-E3
I cant find a source
I read about casper having a few, but their page doesnt list them.
I cant find a source
I read about casper having a few, but their page doesnt list them.
Supreme Member
iTrader: (2)
Joined: Jan 2002
Posts: 9,962
Likes: 5
From: Moorestown, NJ
Car: 88 Camaro SC
Engine: SFI'd 350
Transmission: TKO 500
Axle/Gears: 9-bolt w/ 3.23's
Re: RN PROM Holder Source Needed
Im pretty sure these have been out of production for quite some time, and are no longer available. They where used up to around 95 or so, I think, in the C3 TBI ECMs, but havent been used since. You could always solder in a zif, bypassing the need for the holders.
Thread
Thread Starter
Forum
Replies
Last Post
