I went from the stock 19.76lbs/hr injectors to 29.45lbs/hr injectors. A difference of 32.9%.

Now, I changed the injector flow rate in bin. I know that the VE table values don't need to be lowered by 32.9% across the board because the bin takes into account the injector flow rate in it's own math. Of course I did have to make some minor adjustments in the lowest VE table parameters and the highest. I was rich in the very lows and lean in the very highs, the mids were perfect actually!

My question is in regards to other tables like the "Crank Pulse Width" and any others that may NOT adjust automatically that I should lower by 32.9% as a starting point.

Any thoughts?

Thanks!

Alex