EBL; First impressions
Thread Starter
Member
Joined: Feb 2009
Posts: 119
Likes: 0
From: Delta, BC
Car: '91 S10 Blazer
Engine: TBI 350
Transmission: 700R4
Axle/Gears: 3.73 posi
EBL; First impressions
Wow. (there. first impression.
)
But seriously.... I went from an engine that would barely even run without burning itself down (it had got so hot at one point I torched two silicone 8mm plug wires!), to being able to sit and idle on it's own after only about 10 min's. I haven't even altered one of the many included BIN's yet!
Build quality of the board is awesome, as is the ease of installation (I did the self install; had the old parts out, and the new one in, and the case modded in under an hour).
If anyone else is even hesitating on should I/shouldn't I - Do it!
It could just be the best money you've spent on your project.
)But seriously.... I went from an engine that would barely even run without burning itself down (it had got so hot at one point I torched two silicone 8mm plug wires!), to being able to sit and idle on it's own after only about 10 min's. I haven't even altered one of the many included BIN's yet!
Build quality of the board is awesome, as is the ease of installation (I did the self install; had the old parts out, and the new one in, and the case modded in under an hour).
If anyone else is even hesitating on should I/shouldn't I - Do it!
It could just be the best money you've spent on your project.
Thread
Thread Starter
Forum
Replies
Last Post




