Correct PROM for 89 TPI Auto Trans 3.27
Thread Starter
Joined: Dec 2012
Posts: 407
Likes: 10
From: Clarksville,TN
Car: 1989 GTA
Engine: 5.7 w/Paxton
Transmission: 700R4
Axle/Gears: 3.27
Correct PROM for 89 TPI Auto Trans 3.27
The PROM itself has a sticker with "Delco APYU 3516" that I can see through the hole in the blue carrier. Is that label the correct label for this car? THE ECM is a 165.
Someone mentioned if the prom had been erased then the sticker would have to be removed for the UV light and that would ruin the above sticker. Is this correct? It sure doesn't look like it has been tampered with around the edges.
Thanks in advance. Still chasing tail with this car...one day I WIll catch it though. I think I can; I think I can; I think I can.
Someone mentioned if the prom had been erased then the sticker would have to be removed for the UV light and that would ruin the above sticker. Is this correct? It sure doesn't look like it has been tampered with around the edges.
Thanks in advance. Still chasing tail with this car...one day I WIll catch it though. I think I can; I think I can; I think I can.
Joined: Dec 2004
Posts: 16,774
Likes: 1,002
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: Correct PROM for 89 TPI Auto Trans 3.27
The broadcast code apyu is correct for a 89 f-body tpi 5.7L 700r4 transmission, 3.27 gears, federal emissions.GM 16133476. it does take along time for just sunlight to flip bits but under direct uv light it take 10 minutes or less to completly erase the eprom.
Thread Starter
Joined: Dec 2012
Posts: 407
Likes: 10
From: Clarksville,TN
Car: 1989 GTA
Engine: 5.7 w/Paxton
Transmission: 700R4
Axle/Gears: 3.27
Re: Correct PROM for 89 TPI Auto Trans 3.27
Thanks again for responding to my posts. I swear I will figure this car out or die trying. This pretty much rules out a bad "tune" then I presume.
Joined: Dec 2004
Posts: 16,774
Likes: 1,002
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: Correct PROM for 89 TPI Auto Trans 3.27
There rarly ever is a issue with the eprom it self . In the last 14 years I have only run across 2 that has any data loss and they bolth set a code 51. If you would like the memcal read and compared to a known good copy I would be happy to assist just for the shipping cost to help tou out.
Thread Starter
Joined: Dec 2012
Posts: 407
Likes: 10
From: Clarksville,TN
Car: 1989 GTA
Engine: 5.7 w/Paxton
Transmission: 700R4
Axle/Gears: 3.27
Re: Correct PROM for 89 TPI Auto Trans 3.27
I have a couple more things I will try over the weekend (vaccum hoses and fan switch wire). If they don't yield a fix I would appreciate just having you doing a bit check on it. I will PM you.
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
Aug 20, 2017 12:16 AM
84z96L31vortec
North East Region
1
Aug 10, 2015 08:27 PM












