PE when in open loop?
#1
Supreme Member
Thread Starter
PE when in open loop?
My data seems to indicate that when in open loop, PE will not engage even if you meet the criterion to enter PE.
I use SAUJP's open loop idle function and set it to 1500 rpm.
When I go WOT from a standstill the data seems to indicate that I don't engage PE until after 1500 rpm. My PE criterion is 60% TPS and 50 kPa, which I easily meet coming off the line like that.
So is that how the $8D code is set up? That PE is only available in closed loop?
And that my WOT AFR below 1500 rpm is actually controlled by the OL AFR?
I use SAUJP's open loop idle function and set it to 1500 rpm.
When I go WOT from a standstill the data seems to indicate that I don't engage PE until after 1500 rpm. My PE criterion is 60% TPS and 50 kPa, which I easily meet coming off the line like that.
So is that how the $8D code is set up? That PE is only available in closed loop?
And that my WOT AFR below 1500 rpm is actually controlled by the OL AFR?
#2
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,402
Likes: 0
Received 215 Likes
on
201 Posts
Car: check
Engine: check
Transmission: check
Re: PE when in open loop?
PE mode isn't dependent upon being in open or closed loop (stock AXCN here). There is no check for this in the PE code.
There is a check late in the routine that does check if the ECM is in open loop. If so then the calculated PE AFR is compared to the open loop commanded AFR. The ECM uses whichever one is richer.
The stock ALDL stream doesn't have the PE mode bit in the data stream. This could be changed as it is an handy flag to have available when tuning.
RBob.
There is a check late in the routine that does check if the ECM is in open loop. If so then the calculated PE AFR is compared to the open loop commanded AFR. The ECM uses whichever one is richer.
The stock ALDL stream doesn't have the PE mode bit in the data stream. This could be changed as it is an handy flag to have available when tuning.
RBob.
#3
Supreme Member
Thread Starter
Re: PE when in open loop?
Thanks! That's great info.
The SAUJP tunerpro xdf/adx files do output the PE status. That's prompted me to ask this question...it seemed that PE wouldn't show as engaged below 1500 rpm.
The SAUJP tunerpro xdf/adx files do output the PE status. That's prompted me to ask this question...it seemed that PE wouldn't show as engaged below 1500 rpm.
#4
Supreme Member
Join Date: Jun 2012
Location: Canada
Posts: 1,226
Received 149 Likes
on
122 Posts
Car: '91 Firebird Formula
Engine: SP383 Deluxe FIRST® TPI Intake
Transmission: Tremec T56
Axle/Gears: Moser 9" Eaton Truetrac Motive 3.89
Re: PE when in open loop?
Thread
Thread Starter
Forum
Replies
Last Post
Zach/90\irocZ
DIY PROM
0
07-05-2015 02:20 AM