Hi
Anyone has values for Offset compensation vs Battery voltage and Short PW Compensation vs Pulse Width?

And injector constant if itīs not 19.50

Bosch 0 280 150 943

regards Fredrik

 

Are these the fat Bosch yellow tops?

RBob.

 

Yes. That’s correct!

Car’s running rich in open loop. Especially during cranking

 

OK, these values should match.

Minimum PW @ 42 psi: 0.886

Offset Compensation versus Battery Voltage:
6.4 Volts: 3197 usec
8.0 Volts: 1925 usec
9.6 Volts: 1358 usec
11.2 Volts: 1029 usec
12.8 Volts: 795 usec
14.4 Volts: 633 usec
15.0 Volts: 574 usec*

Flow rate: 20.0 #/hr

RBob.

 

Thanks!

 

I use TunerPro and $6E XDF but I canīt find a Scalar for Minimum PW. Where can I change that value?

 

Or is it Minimum Enrich Async Pulse Width? Current value 1.69 mSec

In $58A there is a value called Minimum Base Pulse Width. But I donīt find that in $6E. Only the one above

 

I just found an Extended 6E here Expanded 6E definition file for Tunerpro - Page 2 - Third Generation F-Body Message Boards
This xdf has a scalar for Min Base PW.
Is this safe to use?