I had my Innovate WB reporting to its software in controller and to pillar gauge. I recall them showing the same data as far as A/F.

I then patched into EBL-WU and I do not recall then reporting a differing A/F from pillar gauge. The WU is regularly showing 1.5 points leaner and sometimes the same as pillar gauge .

Is there an offset that needs an adjustment in EBL for that deviation?

Thank you!

 

You need to set the WB controller to report zero volts for 7.5 afr and 5v for 22.39afr

 

Thanks. I will did up owners manual....

 

Innovate automatically sets at that V by user selecting fuel in use. In my case E10. Stoich is reported at 14.7/1 or 1.0 Lambda,