knock sensor question on a 165 to 730 swap
Thread Starter
Junior Member
Joined: Feb 2001
Posts: 36
Likes: 0
From: Hayes, VA
knock sensor question on a 165 to 730 swap
I am converting to a 730 and know the knock sensor is different for the 90-91 cars. I've read that the ohms are what makes up the difference? If this is so, can I just run a direct wire from the 165 knock sensor and put a resistor inline to cut the ohms back? Thus making the 730 a happy camper?
Supreme Member
iTrader: (1)
Joined: Jan 2002
Posts: 4,432
Likes: 1
From: garage
Engine: 3xx ci tubo
Transmission: 4L60E & 4L80E
Wes, you can. Measure the resistance of each knock sensor and put the proper resistance in parallel or series to make the sensor appear to be correct to the ECM
J
J
Thread Starter
Junior Member
Joined: Feb 2001
Posts: 36
Likes: 0
From: Hayes, VA
Thank you. Just wanted to make sure. I plan to make a quick disconnest deal that will allow me to go back to the 165 knock setup without doing anything but switching wires. Wish me luck.
Thread
Thread Starter
Forum
Replies
Last Post
