Steering column compatability....
Thread Starter
Supreme Member
Joined: Aug 1999
Posts: 1,053
Likes: 3
From: San Diego, CA
Car: 87 Buick GN
Engine: 3.8L (231 cid) V6
Transmission: 200-4R
Axle/Gears: 10 bolt G80/ 3.42
Steering column compatability....
Stupid question...will a steering column from a manual trans car bolt right into a car that's an auto? I'm not concerned with the VATS either. Thanks guys.
------------------
1989 IROC-Z, ZZ3 shortblock with some bolt-ons.
13.20 @ 108.69, 2.2 60' on "Road Hugger" radials and dead Auburn posi.
------------------
1989 IROC-Z, ZZ3 shortblock with some bolt-ons.
13.20 @ 108.69, 2.2 60' on "Road Hugger" radials and dead Auburn posi.
Supreme Member
Joined: Jul 1999
Posts: 1,335
Likes: 2
From: Tucson, AZ, USA
Car: '92 Z28; Dk Teal; Her Pkg
Engine: 305
Transmission: Richmond 6 Spd
Axle/Gears: Moser 9", Detroit Locker, 3.70
The only differences I can think of are the cable that goes from the auto trans shifter to the ign switch - but the ign switches may be the same, and if not, they could be swapped, and the manual column will have an ign tumbler with a button on it that has to be pressed to turn off the ign - the tumblers could probably be swapped, too.
Tim
Tim
Thread
Thread Starter
Forum
Replies
Last Post
sjorgens
Suspension and Chassis
7
Oct 1, 2015 07:54 PM