Safety Switch mounting
Thread Starter
Senior Member
Joined: Oct 2000
Posts: 659
Likes: 0
From: Chesapeake, VA
Car: '86 TransAm WS6
Engine: 305 TPI
Transmission: Custom TH700R4
Safety Switch mounting
I'm moving my battery to the trunk for better balance. I was planning to install a cut-off swith for track days.
My Idea: install the switch in an A-pillar guage pod. Think it'll work?
My Idea: install the switch in an A-pillar guage pod. Think it'll work?
Moderator
Joined: Jan 2000
Posts: 20,981
Likes: 11
From: Mercedes Norte, Heredia, Costa Rica
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
The cutoff switch must be located outside the car.
[This message has been edited by Apeiron (edited February 08, 2001).]
[This message has been edited by Apeiron (edited February 08, 2001).]
Supreme Member
Joined: Jan 2001
Posts: 1,978
Likes: 0
From: PA
Car: 88 Firebird WS6
Engine: 350 TPI
Transmission: T56
Axle/Gears: 3.42
and on the back panel.... and clearly labeled... and installed on the + terminal (even though it makes more sense to put it on the -)
Thread
Thread Starter
Forum
Replies
Last Post
Street Lethal
Power Adders
634
Apr 30, 2019 12:14 PM