Expolding Distributor
Thread Starter
Junior Member
Joined: Jan 2001
Posts: 30
Likes: 0
From: phoenix az
Expolding Distributor
Ok heres the story I just got a wrecked Firebird for a parts car. The engine is going in my 84 Z28. Anyways I was test running the engine and when i revved it up i heard a pop. Went to the engine bay and the distibutor cap was in pieces. The rotor flew a good 5 feet. Anyone ever heard of this happening before? What caused this? Luckely I still have the distributor from my camaro
Supreme Member
Joined: Jan 2001
Posts: 1,746
Likes: 0
From: Tucson, AZ
Car: 1991 Z-28
Engine: Can you say stroke?!?!
Transmission: 700-r4
Axle/Gears: 3.42
Probably just a bad cap and rotor. Never seen it happen but I guess anything is possible. You can "MOST" likely use the ones off the camaro but you'd be better off buying new ones. You could get them for about 20 bucks.
------------------
'91 Z-28 5.7, SLP 1 3/4 headers, 4 inch Mufflex/Flowmaster cat back, gutted cats, Edelbrock intake, 8.5mm Jacob wires, MSD Blaster coil, S&W subframe setup, Jacob Pro Street Ignition, complete Kenwood system.
------------------
'91 Z-28 5.7, SLP 1 3/4 headers, 4 inch Mufflex/Flowmaster cat back, gutted cats, Edelbrock intake, 8.5mm Jacob wires, MSD Blaster coil, S&W subframe setup, Jacob Pro Street Ignition, complete Kenwood system.
Thread
Thread Starter
Forum
Replies
Last Post
RedLeader289
Tech / General Engine
10
May 28, 2019 01:47 PM
HoosierinWA
Tech / General Engine
5
Oct 7, 2015 10:15 AM
Damon
Tech / General Engine
8
Sep 26, 2015 04:29 PM
