Help with wire Identification
Thread Starter
Member
Joined: May 2002
Posts: 112
Likes: 0
From: St. Louis, MO
Car: 1985 Berlinetta
Engine: 305 4BBL
Transmission: 700r4
Help with wire Identification
I have an 85 Berlinetta 5.0 LG4 motor vin H. Bought the car with a blown motor that had been replaced before. Unfortunately, some things I think have been "re-engineered". Found some melted wires and fixed those. However, I found 2 more that I am not sure where they go.
One is orange with a black stripe and the other is black with a purple stripe. They are harnessed together. If there was a plastic plug on the end it is gone, both wires appear to have small bullets on the end like they plugged into something. They come up on the passenger side near the carb. The elec choke has only one thing plugging into it, right?
Any ideas
One is orange with a black stripe and the other is black with a purple stripe. They are harnessed together. If there was a plastic plug on the end it is gone, both wires appear to have small bullets on the end like they plugged into something. They come up on the passenger side near the carb. The elec choke has only one thing plugging into it, right?
Any ideas
Thread
Thread Starter
Forum
Replies
Last Post
Glowsock
Tech / General Engine
3
Jan 9, 2017 04:06 PM




