Hi everyone,
I have a 1985 Camaro Z-28 that I have swapped a crate GM Goodwrench 350 into. It is not running. Yet. This is where I hope some of ya'll may be able to help me.

I need to know how to wire my Mallory Unilite distributor. I had to get rid of the computer controlled dist. and I've also replaced the intake manifold with an edelbrock performer and the carb is now an edelbrock performer 600 cfm. I have yet to see if they are the culprit of anything or not because I cannot even get spark from my distributor.

Basically what I need to know is how I should wire the Hot Wire for the Coil. I have seen schematics and what not about it, but I need to know what to do to get a Hot Wire for the ballast resistor; for the coil. I have it wired properly, but I cannot find a Hot wire. I need suggestions on what to do.

Any help at all would be appreciated.