Need help with finding a wiring harness for a carb motor
Thread Starter
Supreme Member
iTrader: (16)
Joined: Dec 2001
Posts: 2,006
Likes: 1
From: Tiffin OHIO
Car: 1987 Iroc-z Convertible
Need help with finding a wiring harness for a carb motor
anyone know who can make a harness for engine bay for my 87 Iroc? I am swapping a 406 carb motor with HEI (79 one wire hookup) and electric choke and deleting emissions and a/c. also cruise will be electronic (aftermarket). I want something to clean up engine bay. Also if I can find a dash harness that will eliminate wiring under dash for everything that won't be used. Any help Would a Painless 18 circuit kit work as far as this goes? Thanks in advance for any info.
Supreme Member
iTrader: (3)
Joined: Feb 2003
Posts: 2,065
Likes: 0
From: California
Car: 1982 Trans Am & 1982 Corvette
Engine: L-98 with LO-3 induction. 350 CFI
Transmission: 5 speed and vette has 700r4
Axle/Gears: 373's in T/A .. vette unknown
why dont you just eliminate circuits out of your existing harness that you dont need it's not that hard
Supreme Member
iTrader: (3)
Joined: Feb 2003
Posts: 2,065
Likes: 0
From: California
Car: 1982 Trans Am & 1982 Corvette
Engine: L-98 with LO-3 induction. 350 CFI
Transmission: 5 speed and vette has 700r4
Axle/Gears: 373's in T/A .. vette unknown
just remove the ecm harness and and the car will run fine
Thread
Thread Starter
Forum
Replies
Last Post