Howday,

I recently bought my 91 RS off a dude, and it came with a replacement pass door-the one on there now is all banged up and can't be locked from the inside.
Sooo, this is my first project and it's a miracle I made it this far. I got the Trim off, disconnected the the wires to the motors and such, and am now at the stage where I have to pull the wires through the conduit back into the vehicle so I don't rip them off when i take off the door.

The wires appear to be attatched to the conduit, I am unsure if it's by tape or clips or what? But most importantly I would like to know how to remove the conduit without damaging it. All the books and sites I've looked up just simply say "remove conduit." It looks like the head of it (the wider diameter part that is past the door) should come off the main conduit, but I don't want to break anything.

Any advice or suggestions would be much appreciated!
Thanks alot!
-Barry W

 

if i remeber correctly doesnt it just pull throught...all the conduit is is some ruber isnt it?

 

Yes it's the rubber deal, but it mushrooms out up against the door on the inside door side. I haven't quite tried pulling it too much yet. the damn inner door frame makes it difficult to prod around in there.

 

Yea im pretty sure theres nothing holding it other then its larger mushroom thing, so just compress it down alittle and push it through the hole

 

Alrighty, thanks alot man. I'll give it a shot in a few days after this damn holiday stuff. Merry X mas