MSD 6A
Thread Starter
Junior Member
Joined: May 2006
Posts: 51
Likes: 0
MSD 6A
Ok well i have an MSD 6A and i hooked it up, i bought the harness so it is hard to mess up installation, match the colors, no i have also taylor race wires. when i drive feels like my car hesitates and it sometimes shuts off and wont start up right away, it also backfires some times. and help? before i sell it, cause my car runs fine without it, i have also a msd cap rotor and coil....
Senior Member
iTrader: (1)
Joined: Apr 2004
Posts: 536
Likes: 0
From: Prescott Valley AZ
Car: 87 Iroc Showcar - Saturday Nite Hun
Engine: 383 4-Bolt Truck Hyd Roller MiniRam
Transmission: B&M 700R4 - Edge 3200
Axle/Gears: BW 9 Bolt-TA Cover & Stud Kit - 3.2
MSD 6A
Hi,
If your sure its wired rite and have problems, but no
problems without it, could be bad unit.
If new, send it back for another one, new ones have
been known to have problems.
If bought used could be the reason was sold
Good luck
later
If your sure its wired rite and have problems, but no
problems without it, could be bad unit.
If new, send it back for another one, new ones have
been known to have problems.
If bought used could be the reason was sold
Good luck
later
Thread
Thread Starter
Forum
Replies
Last Post
RedLeader289
Tech / General Engine
10
May 28, 2019 01:47 PM
sreZ28
Engine/Drivetrain/Suspension Parts for Sale
5
Oct 22, 2015 08:21 AM
86CamaroDan
Engine/Drivetrain/Suspension Parts for Sale
2
Sep 29, 2015 10:08 PM