Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

97 Pontiac sunfire anti-theft problems? URGENT

Thread Tools
 
Search this Thread
 
Old Dec 7, 2006 | 04:58 PM
  #1  
fast_trucks's Avatar
Thread Starter
Junior Member
 
Joined: Dec 2006
Posts: 2
Likes: 0
97 Pontiac sunfire anti-theft problems? URGENT

I am new here.
I need urgent help. My wifes Sunfire supposedly ran out of gas last night. I showed up with a few gallons but it wouldn't start. I figured she probley tried to start it a few times and killed the battery. I tried to jumper it, but it wouldn't budge. Next, I jumpered the solenoids on the starter. It would turn over but wouldn't take off. Thats when We noticed a "security" light flashing. So I had my buddy turn the ignition while I jumped the solenoid and it took right off. After I got the car home and shut it off it wouldn't start again with the key.
Do I need to reset something in the ECM for the security? Any other ideas? This is my wifes ride to work. Thanks
Reply
Old Dec 7, 2006 | 05:37 PM
  #2  
smartman__007's Avatar
Member
15 Year Member
iTrader: (1)
 
Joined: Jun 2006
Posts: 254
Likes: 1
From: South Dakota
Car: 1990 Camaro RS
Engine: 305 TBI (LO3)
Transmission: T-5
Axle/Gears: 3.08
not 3rd gen related but I'll bite. I'm positive it's got a Pass-KeyII system. My friends Grand Prix had the same problem. There's a small RF type chip i do beleive in the key. If it doesnt read the write RF tag the car wont start. Check the Pass-KeyII module underneath the steering column right next to the steering wheel. Dealership should be able to diagnose no problem.
Reply
Old Dec 7, 2006 | 09:45 PM
  #3  
fast_trucks's Avatar
Thread Starter
Junior Member
 
Joined: Dec 2006
Posts: 2
Likes: 0
I know it's not related, but I was sent here from another site. There is no chip in the key. I have 4 keys to this car, 3 being cut a few years ago at my local "ACE Hardware". After talking with the dealer that my father works at as a salesman, they gave me a procedure to "program" the security function. I was to turn on the ignition, wait for 10 min. then turn off without trying to start the motor. I was to repeat this 3 times before attempting to start. The only catch is that the "theft control" light is supposed to be flashing. I have never been able to get it to flash. I have also left the battery disconnected overnight.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
jhawkeye
Engine Swap
5
May 25, 2022 06:33 PM
1Aauto
Sponsored Vendors
3
Nov 23, 2015 02:17 PM
thefirebirdm@n
South Central Region
3
Sep 14, 2015 01:45 PM
1Aauto
Sponsored Vendors
0
Aug 26, 2015 02:18 PM
1Aauto
Sponsored Vendors
0
Aug 26, 2015 02:14 PM




All times are GMT -5. The time now is 08:02 PM.